← BACK TO RESULTS
EMANON PART NO.
MS20426D3-4
MS20426D3-4 is a rivet in aluminum alloy 2017, anodize or oxide film finish, 0.093 INCHES MINIMUM AND 0.097 INCHES MAXIMUM diameter and 1/4 length.
Rivet
SPECIFICATIONS
KEY DIMENSIONS
DIAMETERMinimum 0.093 in; maximum 0.097 in
LENGTH0.250 in (1/4)
GRIPBetween 0.099 inches and 0.119 inches
HEAD & SHANK
HEADFlush (flat) countersunk (included angle - less than 135 degrees w or w/o chamfer)
HEAD DIAMETER0.175–0.183 in
SHANK STYLED10 straight with radius chamfered tip
SHANK DIAMETER0.093–0.097 in
MATERIAL & FINISH
MATERIALAluminum alloy 2017
MATERIAL SPECQQ-A-430 — FED SPEC
FINISHAnodize or oxide film
FINISH SPECMIL-A-8625 or MIL-C-5541
MECHANICAL
SHEAR STRENGTH33,000 psi
STANDARDS & TRACEABILITY
NSN5320-00-117-6394
FLIS · NSN 5320-00-117-6394 · retrieved 2026-08-09
DOCUMENTS
✓Certificate of Conformance & test reports available for most products (standard cert fees apply)
No drawing on file — request it
Fastener Length: 1/4, roughly 5,003 pieces per pound
Emanon is a stocking distributor — quality-system certifications are held by the certified manufacturers we source from, not by Emanon. Every shipment carries manufacturer certifications and full lot traceability.